Additin® RC 5202

Type

Water-soluble EP-additive for water miscible metal working fluids

Application

– fully synthetic metal working fluids (oil-free)
– semi-synthetic metal working fluids (low oil content)
– substitution of EP-emulsions by oil-free aqueous EP-solutions
– tank-side-addition of metal working solutions

Additin RC 5202 is a clearly water-soluble EP-additive used for severe metal working operations with fully
synthetic fluids (e.g. ironing of tins or fine wire drawing). Typical treatment levels in MWF concentrates are 3 to 15
%. For tank-side addition of metal working solutions 0,2 to 0,5 % are used.

For supporting lubricity and AW-performance a combination with Additin RC 5010 (e.g. ratio 1 part RC 5202 and 1
part RC 5010) is recommended.

If Additin RC 5202 is used as tank-side-additive for metal working solutions, pay attention that lubricity additives
(e.g. Additin RC 5010) are already in the solution.

Solubility

Additin RC 5202 is generally well soluble in water miscible concentrates with a high water content (> 30 %).
However, it is necessary to verify the solubility in the base fluids used and the compatibility with other additives.

Used as tank-side additive Additin RC 5202 is soluble by sufficient turbulence of the metal working solution.

Packing Unit

240 kg bunghole drums

Storage Conditions

protected from light and in a dry place at room temperature approx. 24 months

Handling

Consult material safety data sheet (MSDS) for additional handling information on Additin RC 5202..